Hydrofluoric Acid was used to “etch” or rough up the surface of the bathtub which would then help the coatings to stick to the porcelain bathtub or tile. If this material is mishandled it can cause damage to fixtures, floor tile or burns to the skin of the technician.

Adhesion Promoter

Bonding agents are basically a type of “super glue”. When this “super glue” is applied to the surface of the bathtub, the new coating will be chemically fused to the surface of the bathtub. This process has proven to be the best method to allow coatings to adhere to the surface and is less likely to peel. Surface Solutions, LLC uses only the most advanced and effective methods for resurfacing.

Steps Taken to Refinish a Bathtub

The bathtub is scrubbed clean with a powerful detergent that will remove any soap film build-up or residual film left behind by household cleaners.
The tub is rinsed and dried completely to remove all moisture.
Paper masking is installed around the tub to prevent overspray from getting on the tiles. Other areas of the bathroom will be masked off with plastic if necessary.
Bonding agent is applied to the surface of the tub.
High Gloss Acrylic Urethane topcoat is applied.

During our resurfacing process, a ventilator is used which helps remove overspray and fumes from the bathroom area. It pulls the air from the room and with it the overspray and dust particles. This piece of equipment is placed in the window of the bathroom, or if there is no window in the bathroom, a hose is attached and directed to the nearest window or door. All materials are applied using an HVLP spray system.

Materials Used to Refinish a Bathtub

Specifically formulated bonding agent for use on porcelain bathtubs and ceramic tile only.
When appropriate, we use another bonding agent that is designed specifically for fiberglass shower/tub units.
The finish coating is a high performance; two-component chemically cured Aliphatic Acrylic Urethane Gloss Enamel. This product provides resilence to cracking and yellowing. It has terrific stain resistance and color retention. 4H pencil hardness makes this product one of the most durable on the market.

Why Should I Choose to Refinish?

Tub surface is worn from years of cleaning with abrasive cleaners such as Ajax or Comet.
The surface is difficult to keep clean.
The color of your bathtub, countertops, or fixtures is outdated.
The surface has become damaged or was chipped.
Save thousands of dollars vs. replacing.
Back in service in 24 hours vs. 1 - 2 Weeks.